PureConnect

 View Only
Discussion Thread View
  • 1.  Acd Initiate Bullseye Processiong Tool

    Posted 05-10-2019 01:22
    Although it was not in 2018R5, a tool called "Acd Initiate Bullseye Processiong" is added to InteractionDesigner in 2019R1.

    It looks like you haven't written in the release notes, is this a new feature?
    Is there anything related to PureCloud?

    do you know?
    #Handlers

    ------------------------------
    Yusuke Higashino
    Itochu Techno-Solutions Corporation(CTC)
    ------------------------------


  • 2.  RE: Acd Initiate Bullseye Processiong Tool

    Posted 05-10-2019 07:25
    Edited by Rasko Radojevic 05-10-2019 07:27

    Thank you @Yusuke Higashino because thanks to your update I just noticed this tool on internal server.

    From Interaction Designer documentation it's in the part "What's new"

    https://help.genesys.com/cic/mergedProjects/wh_id/desktop/what_is_new_in_cic_2019_r1_.htm

    and there's article about tool

    https://help.genesys.com/cic/mergedProjects/wh_id/desktop/acd_initiate_bullseye_processing.htm

    and in ACD TR document there's updated part

    https://help.genesys.com/cic/mergedProjects/wh_tr/mergedProjects/wh_tr_acd_processing/desktop/types_of_acd.htm

    Bullseye routing, which is available only with a custom workgroup, assigns interactions to agents based on selection pools. Picture a target with a bullseye in the center and four rings around the bullseye. One or more agents are assigned to the bullseye (ring 1) and to each of the rings, 2-5, outside of the bullseye. Each ring has a configured timeout.

    Bullseye routing is not configurable from workgroup configuration. You assign agents and a timeout to each ring using the ACD Initiate Bullseye Processing tool in Interaction Designer. Assign the preferred agents to ring 1, the bullseye, so they are considered first. For more information about the tool, see ACD Initiate Bullseye Processing in the Interaction Designer help.



    ------------------------------
    Раско Радојевић
    Rasko Radojevic
    ------------------------------



  • 3.  RE: Acd Initiate Bullseye Processiong Tool

    Posted 06-14-2019 03:40

    Sorry for not replying sooner.
    I did not know that there were release notes(What's New!) for Designer until I saw this note.

    Thank you for your update!

    ------------------------------
    Yusuke Higashino
    Itochu Techno-Solutions Corporation(CTC)
    ------------------------------



  • 4.  RE: Acd Initiate Bullseye Processiong Tool

    Posted 07-15-2019 12:27
    Most important part is the fact that you will have to program a lot of the ACD logic, since you have to configure the ACD routing as custom. Make sure that all the functionality you need is available before pushing this to production.

    Since our customers don't have knowledge to develop / change handlers,  we designed Bullseye Routing to also work with the standardized ACD routing. It requires a set of custom handlers and configuration in Structured Parameters.

    ------------------------------
    At 3Fiftynine impossible is just a challenge

    We provide kick-ass products on top of Genesys platforms
    ------------------------------



Need Help finding something?

Check out the Genesys Knowledge Network - your all-in-one access point for Genesys resources