Genesys Cloud - Main

 View Only

Discussion Thread View

  • 1.  BYOC EDGE Configuration

    Posted 04-17-2024 04:36

    Hi everyone,

    I am currently seting up BYOC Premise - Customer Hardware Solution Edge in our enviornment but we are having the following issue.

    We are on HPE Proliant DL360 Gen11 with Genesys recommanded specs.

    We have followed the steps below regarding the RAID 1 confuguration but we are still getting the error below.

    Note: The Customer Hardware Solution – Small requires three (3) internal hard drives. The BYOC Premises – Customer Hardware Solution installer sets up two of the hard drives in a RAID 1 configuration and then sets up the third hard drive for support purposes. More specifically, the third drive stores local media used for factory image restoration and provides space for over-the-air operating system upgrades.

    Note : We have made the setup for more than 30 HPE Proliant Microserver V2 and we did not get this issue.

    Thanks in advance for your help.


    #Implementation

    ------------------------------
    Maguitte Christopher
    Groupe Canal+ SA
    ------------------------------


  • 2.  RE: BYOC EDGE Configuration
    Best Answer

    Posted 04-23-2024 22:04

    With the recipe, you have to follow it to the "T".  Every component must be the same as what is listed in the resource article and set up exactly as they want it set up.  Any deviation would be the cause of this failure message.  I would guess this list would be easier to follow:  https://www.foodrepublic.com/1354881/most-difficult-dishes-make-from-scratch/



    ------------------------------
    Robert Wakefield-Carl
    ttec Digital
    Sr. Director - Innovation Architects
    Robert.WC@ttecdigital.com
    https://www.ttecDigital.com
    https://RobertWC.Blogspot.com
    ------------------------------

    Original Message


Need Help finding something?

Check out the Genesys Knowledge Network - your all-in-one access point for Genesys resources